Easy to use laser show software and controllers for ILDA or DMX laser › Forums › Moncha › Moncha General Discussion › DB 25
- This topic has 3 replies, 1 voice, and was last updated 14 years, 8 months ago by
Anonymous.
- AuthorPosts
- August 29, 2007 at 9:26 pm #675
Anonymous
Moncha uses standard ILDA connector. Here are the pins:
1 X+ /-5 to +5V/
2 Y+ /-5V to +5V/
3 Blanking TTL /0V or +5V/
4, 7 Interlock /inside of device connected together/
5 Red /0V to +5V/
6 Green /0V to +5V/
7 Blue /0V to +5V/
8, 9, 10, 11, 12, 24 Not connected
13 Shutter /0V for blanked, +5V for visible/
14 X- /-5 to +5V/
15 Y- /-5 to +5V/
16,18,19,20,21, 22,23,25 GNDMichal
August 29, 2007 at 9:26 pm #459Anonymous
Moncha uses standard ILDA connector. Here are the pins:
1 X+ /-5 to +5V/
2 Y+ /-5V to +5V/
3 Blanking TTL /0V or +5V/
4, 7 Interlock /inside of device connected together/
5 Red /0V to +5V/
6 Green /0V to +5V/
7 Blue /0V to +5V/
8, 9, 10, 11, 12, 24 Not connected
13 Shutter /0V for blanked, +5V for visible/
14 X- /-5 to +5V/
15 Y- /-5 to +5V/
16,18,19,20,21, 22,23,25 GNDMichal
August 30, 2007 at 12:48 am #676Anonymous
I am not currently using the interlock pins. Could you tell me what they are for?
August 30, 2007 at 11:37 am #677Anonymous
Interlock pins are used for safety reasons. Some lasers might have protection – if the interlock pins are NOT shorted, the laser won’t run(it means, no signal cable is connected to laser).
Michal
- AuthorPosts
- You must be logged in to reply to this topic.