Easy to use laser show software and controllers for ILDA or DMX laser › Forums › Fiesta! and Fiesta.NET (old fiesta for Windows) › Fiesta! General Discussion › laser problem if you can help me ..
- This topic has 3 replies, 2 voices, and was last updated 13 years ago by
ZeroWaitState.
- AuthorPosts
- November 4, 2008 at 1:39 am #516
Hello .. i have a problem with my new rgb 🙁 ( any suggestions ? thanks ..
November 4, 2008 at 4:12 pm #873Anonymous
If your Fiesta is working with other laser system, the only problem is bad ILDA cable/connector. Check your laser manual, if it uses standard ILDA connector.
Michal
March 27, 2009 at 5:15 am #897Definatly check your cabeling, i purchased a cable from kvant and the interlock pins were not shorted ( as they do this internally on thier projectors i believe) this caused me some problem initally as i have crap rgb from china an had a similar issue to what you mention.
Som projectors will not work if the correct pins are not shorted as per the ILDA spec.
May 22, 2009 at 5:55 am #919quote quietlee”:k49vy7jm:Please can you give me the pinout of what pins should be shorted out to make this dot thing goaway as I have the same problem.Thanks
this is a snip of a reply email from Dusan when i had this proble a year or so back
>>SNIP
Dear Ben
About ILDA cable, all our cables are tested so I thing that problem was other.
I thing that with pin 7 and 14 because in standard it is for Interlock but our lasers don’t need it so this pins are conected directly together in our laser.
Our interlock is provided another. If the signal not going to laser than laser are not running so we don’t need pin 7 and 14.
Please in attachment you will find description of our conection and standard conection like is recomended by Pangolin.
So please checkit.
So if ther was another problem Let me exactly where was problem according you.Thanks a lot,
<< END SNIP You may find that this will this will fix the problem as i found the cable supplied by Fiesta did not have these pins wired at all, which is fine if used on thier projectors but cab be problematic when used on other units. If you go the the laserfx web site they have a pin out listing http://www.laserfx.com/Backstage.LaserF … outs9.htmlhope this helps you out, there is nothing more frustrating than having the toys and not being able to play with them.
- AuthorPosts
- The forum ‘Fiesta! General Discussion’ is closed to new topics and replies.