Easy to use laser show software and controllers for ILDA or DMX laser › Forums › Moncha › Moncha General Discussion › Setting up Galvos for moncha
- This topic has 2 replies, 1 voice, and was last updated 13 years, 8 months ago by
Anonymous.
- AuthorPosts
- August 25, 2008 at 11:38 am #857
Anonymous
Well Moncha uses automatic blanking optimization, so for now it is not possible to display ILDA test pattern correctly directly in Moncha software. It is possible to create one small software for you so you could draw your test pattern. Contact us at [email protected] , we’ll send you one soon.
I’m not sure I understand your question correctly. It is possible to copy/paste scenes using menu commands or Ctrl+C and V. Also it is possible to copy/paste show events(using menu or Shift+C/V).
Michal
August 25, 2008 at 11:38 am #510Anonymous
Well Moncha uses automatic blanking optimization, so for now it is not possible to display ILDA test pattern correctly directly in Moncha software. It is possible to create one small software for you so you could draw your test pattern. Contact us at [email protected] , we’ll send you one soon.
I’m not sure I understand your question correctly. It is possible to copy/paste scenes using menu commands or Ctrl+C and V. Also it is possible to copy/paste show events(using menu or Shift+C/V).
Michal
August 26, 2008 at 1:31 pm #858Anonymous
Thanks Gary,
that’s even better solution I believe…
Michal
- AuthorPosts
- You must be logged in to reply to this topic.