Copy and paste multiple scenes in timeline Easy to use laser show software and controllers for ILDA or DMX laser › Forums › Fiesta! and Fiesta.NET (old fiesta for Windows) › Fiesta! General Discussion › Copy and paste multiple scenes in timeline This topic has 3 replies, 2 voices, and was last updated 10 years, 10 months ago by Anonymous. Viewing 4 posts - 1 through 4 (of 4 total) Author Posts May 22, 2010 at 10:09 am #556 Tormod Hi, is it possible to copy and paste a group of scenes in the timeline? I can select many, but when i paste only one is pasted. Also is it possible to change the view mode in devices window? (Only animation, only effect and both)? May 24, 2010 at 5:00 am #999 Anonymous Hi, it should not be a problem, to copy/paste many scenes. You just have to use Ctrl+C and Ctrl+V when with mouse over the show panel. How do you want to change view mode? To disable the laser simulation? Michal May 24, 2010 at 10:33 pm #1000 Tormod Ok, I had the cursor in the wrong place when doing ctrl+c. What i mean about view mode is to view only animation (as most programs do), only beam effects or both (like now). Not important. However, is it possible to have “one shot” scenes that run only one time when pressed? May 27, 2010 at 3:42 pm #1001 Anonymous No, there are no one-shot scenes in Fiesta. You can only create some scene, where at the start something happens and then it turns off (e.g. using Keyframer). Michal Author Posts Viewing 4 posts - 1 through 4 (of 4 total) The forum ‘Fiesta! General Discussion’ is closed to new topics and replies.