Fiesta! 2 USB laser controller Easy to use laser show software and controllers for ILDA or DMX laser › Forums › Fiesta! and Fiesta.NET (old fiesta for Windows) › Fiesta! General Discussion › Fiesta! 2 USB laser controller This topic has 1 reply, 1 voice, and was last updated 13 years, 5 months ago by Anonymous. Viewing 2 posts - 1 through 2 (of 2 total) Author Posts July 31, 2007 at 2:26 am #448 rozil I would like ask about qvaliti of this device. Can somebody take picture from inside (board)? Is it like China or not. Because I won’t bay and I don’t need another China box. July 31, 2007 at 6:35 am #651 Anonymous No, it’s not China at all. Entire development and production is made in Slovakia and Czech republic(EU). This is the picture of the board: The device is properly tested and no problems were found until now. It runs up to 50000pps, 16 bit axes and has 6 color channels. Michal Author Posts Viewing 2 posts - 1 through 2 (of 2 total) The forum ‘Fiesta! General Discussion’ is closed to new topics and replies.