Keframer curves copy

Easy to use laser show software and controllers for ILDA or DMX laser › Forums › Fiesta! and Fiesta.NET (old fiesta for Windows) › Fiesta! General Discussion › Keframer curves copy

  • This topic has 1 reply, 1 voice, and was last updated 15 years ago by Anonymous.
Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 24, 2007 at 7:37 am #434
    PetePete

    I’m not sure copy/cut/paste keyframer curves is working good. Sometimes I can not paste curve from clipboard.

    May 24, 2007 at 12:40 pm #628
    Anonymous

    Yes, you can copy/paste only compatible curves – it means, you can copy and paste between positionX, Y and Z. Than between size X and Y; brigtness, … But you can NOT copy curve e.g. from size X and paste to position X.

    Michal

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • The forum ‘Fiesta! General Discussion’ is closed to new topics and replies.