- This topic has 2 replies, 2 voices, and was last updated 2 years, 2 months ago by
.
-
Posts
-
Hello I want your advice: I am trying to set laser scan rate in hardware settings, it’s very helpful feature, but i don’t know how can i set little correction. If I move slider, then scan rate increases by more than 100 units, however i need increase by 1 unit.
Thank you in advance!Hello Robert
Current version 1.0.81 doesn’t support set scan rate precisely, but we are finishing new version, that contains this feature, where you can increase/decrease scanrate by one unit by scrolling mouse wheel.
New version’ll be released this week.Hello Robert
Today a new version has just been released, that supports mouse wheel to change value by one unit for all sliders (for example: scan rate in Hardware settings, size in laser settings).
Best regards,
Marek Dubovsky
- You must be logged in to reply to this topic.